#!/bin/sh /usr/share/dpatch/dpatch-run ## 01-manpage.dpatch by Daniel Baumann @DPATCH@ diff -Naur micro_proxy.orig/micro_proxy.8 micro_proxy/micro_proxy.8 --- micro_proxy.orig/micro_proxy.8 2005-06-29 17:29:11.000000000 +0000 +++ micro_proxy/micro_proxy.8 2005-11-05 14:19:03.719576104 +0000 @@ -1,6 +1,6 @@ .TH micro_proxy 8 "16 March 1999" .SH NAME -micro_proxy - really small HTTP/HTTPS proxy +micro_proxy \- really small HTTP/HTTPS proxy .SH SYNOPSIS .B micro_proxy .SH DESCRIPTION @@ -8,13 +8,13 @@ .I micro_proxy is a very small HTTP/HTTPS proxy. It runs from inetd, which means its performance is poor. -But for low-traffic sites, it's quite adequate. +But for low\-traffic sites, it's quite adequate. It implements all the basic features of an HTTP/HTTPS proxy, in only 260 lines of code. .PP To install it, add a line like this to /etc/inetd.conf: .nf - webproxy stream tcp nowait nobody /usr/local/sbin/micro_proxy micro_proxy + webproxy stream tcp nowait nobody /usr/sbin/micro_proxy micro_proxy .fi Make sure the path to the executable is correct. Then add a line like this to /etc/services: @@ -21,21 +21,21 @@ .nf webproxy port/tcp .fi -Change "port" to the port number you want to use - 3128, or whatever. +Change "port" to the port number you want to use \- 3128, or whatever. Then restart inetd by sending it a "HUP" signal, or rebooting. .PP -On some systems, inetd has a maximum spawn rate - if you try to run +On some systems, inetd has a maximum spawn rate \- if you try to run inetd services faster than a certain number of times per minute, it assumed there's either a bug of an attack going on and it shuts down for a few minutes. -If you run into this problem - look for syslog messages about too-rapid -looping - you'll need to find out how to increase the limit. +If you run into this problem \- look for syslog messages about too\-rapid +looping \- you'll need to find out how to increase the limit. Unfortunately this varies from OS to OS. -On FreeBSD, you add a "-R 10000" flag to inetd's initial command line. +On FreeBSD, you add a "\-R 10000" flag to inetd's initial command line. On some Linux systems, you can set the limit on a per-service basis in inetd.conf, by changing "nowait" to "nowait.10000". .SH AUTHOR -Copyright © 1999 by Jef Poskanzer . All rights reserved. +Copyright (C) 1999 by Jef Poskanzer . All rights reserved. .\" Redistribution and use in source and binary forms, with or without .\" modification, are permitted provided that the following conditions .\" are met: